A fixed steam cleaning machine is a different purchase decision from a mobile unit. It stays where you install it, runs on mains power, and usually connects to a water supply, so the questions a buyer needs answered are about the site itself: the circuit, the water inlet, the floor space. The product listing is the first place to find out whether the machine suits your location. PowerDe's listing for its fixed model shows the kind of information a serious manufacturer should publish, and it is worth walking through what that listing actually provides.
Where the fixed machine sits in the product range
A good listing starts by positioning the machine honestly. PowerDe's cleaning range includes driving-style units such as the PWD01, PWD02 and HMW2, and hand-pushed units such as the HMW3, several of which run on battery for sites without power. The fixed steam cleaning machine is presented as the opposite kind of tool: a stationary unit that runs on 220 V mains power and takes its water from a tap. Once you know which category a machine belongs to, you can immediately tell whether it fits a fixed wash bay, a fuel-station island, or a cleaning round that has to cover a large area on battery alone.
The specifications the listing publishes
A usable listing answers the practical questions an installer will ask before anyone reaches for a credit card. The page for the PowerDe HW02 steam cleaner provides the following:
- Working voltage and heating power — a 220 V supply and a 6 kW heating element, so you know the circuit the machine needs before an electrician arrives.
- Steam temperature and pressure — a 160 °C steam temperature and 0.8 MPa vapor pressure. These two figures largely determine how quickly the steam loosens baked-on grease and how much force the jet carries.
- Water system — an 80 L tank made of SUS304 stainless steel with a tap-water inlet. Tank material matters wherever water quality or cleaning residue would rust a plain steel tank.
- Operating modes — the machine switches between dry steam and wet steam, and the listing includes a vacuum cleaner in the configuration. That combination is why the page can describe interior cleaning and disinfection, not just exterior spraying.
- Footprint — 1,200 × 800 × 1,200 mm including handles, which you can measure against the space you actually have.
When voltage, temperature, pressure, tank material and dimensions appear on one page, a buyer or a facilities engineer can check compatibility in a single pass instead of exchanging emails for a week.
What the listing says about actual use
The same page also states where the machine is intended to work: vehicle exterior cleaning at gas stations and parking lots, interior vacuuming and disinfection, and engine-compartment cleaning. Read together, these descriptions point to a fixed installation at a fuel station or a parking facility, where operators wash bodies, refresh interiors, and cut the grease in engine bays. If your work is different, the listing format lets you compare the alternatives in the same PowerDe steam cleaning machine category — for example, the fixed HW03 model, which the category listing describes as being used for cleaning and disinfecting hospital beds and medical machinery.
Safety information, and what to confirm separately
The listing covers protection as well: leakage, short-circuit, high-temperature, high-voltage, and water-shortage protection. On a machine that combines water, mains power and high-temperature steam, this list matters as much as the performance figures, because it tells you how the machine behaves when something goes wrong — it shuts the heater down when the tank runs low rather than letting the element burn out.
What no listing can tell you is how the machine performs at your daily volume, whether the hose reaches across your bay, how hard your water is, and whether your supply matches the stated voltage. The listing gives the parameters; PowerDe's contact and solutions pages exist so you can confirm the rest before ordering.
Reading the listing as a whole
Read carefully, a product listing like this one answers three questions at once. What the machine is: a fixed, mains-powered steam unit, not a battery mobile one. What it can do: 160 °C steam at 0.8 MPa, dry or wet, with a vacuum function included. Where it is meant to work: vehicle cleaning at fixed sites such as fuel stations and parking facilities. When a manufacturer publishes all of that up front, you can shortlist with confidence and save the detailed questions for the conversation that actually decides the purchase.
